good brush settings for animation toon boom harmony

HDTV: High definition television delivers a higher quality image than standard television does, because it has a greater number of lines of resolution. You can select your project’s resolution type from this area so it matches your intended output. The different Scene Settings options are separated into three tabs. However, if you want to change these initial settings later, you can.įrom the top menu, select Scene > Scene Settings. It is also possible to use textures when drawing with the Pencil tool.When you created your new scene, you set up the resolution and the alignment. In the Camera or Drawing view, start drawing to test your brush settings.If you want the spacing between each instance of the brush tip to be random, set the Random Spacing setting to any value above 0 %.If you want the angle of your brush tip to be random each time the tip is printed on your canvas, set the Random Angle setting to any value above 0 °.If you want the size of your brush tip to vary each time it's printed on your canvas, set the Random Size setting to any value above 0 %.If this setting is too high, your strokes will look like the brush tip has been stamped repeatedly over your canvas instead of dragged on it. If this setting is too low, your brush strokes might feel too thick and opaque. The default setting is 7%, which produces a relatively realistic brush stroke-like result. Use the Spacing slider to set how much distance you must drag your brush before Harmony prints the brush tip onto your canvas, relative to your brush's size.If you set it to 0 %, the brush will only be opaque in its center, and will gradually become transparent towards its edges. If you set it to 100 %, the brush will be completely solid. Use the Hardness slider to set how much of the outer part of your brush tip should fade to transparency.If you want your brush tip to be at an angle, use the Angle slider to rotate your brush tip.If you want your brush tip to have uneven dimensions, use the Roundness slider to shrink the brush tip vertically all the while preserving its horizontal size.If you don't want the pressure on your pen to affect the brush size, set this parameter to 100%. The minimum size is set to a percentage of your brush tip's maximum size, which is 25% by default. If you are using a pressure-sensitive pen tablet, use the Minimum Size slider to set the size of your brush when using your pen with very little pressure.When drawing with a pressure-sensitive pen tablet, your brush's size will range between its minimum and maximum size, depending on the amount of pressure you put on the pen when drawing. NOTE: When drawing with a mouse, your brush is always at its maximum size.

Good brush settings for animation toon boom harmony